HON perpetual Instrucciones De Instalación página 4

DESK MOUNTED SCREEN ASSEMBLY
5
6
7
8
42-2272E (11/05)
3 of 3
I
1. Insert cardboard spacer (H) into vertical rail channel,
butting it up to the bottom of the channel. Adjust screen
(A) upward until spacer is flush against bottom of
mounting bracket.
NOTE: Failure to use cardboard spacer to accurately posi-
tion bracket can result in product damage.
2. Have second person hold screen in position. Using
Allen wrench, fully tighten two socket head cap screws
(F).
3. Reinstall end cap (D) and flat head socket screw (E)
onto bottom of vertical rail on desk screen (A).
4. Repeat on other side of screen.
Alternate Mounting, 36" deep table:
1. Adjust work surface mounting brackets (C) so flat top of
bracket is flush with long side of desk screen (A).
2. Attach work surface mounting brackets to underside of
work surface with wood screws (G, from hardware
pack), lining up two rear bracket holes with two pilot
holes on work surface, as shown. Tighten screws
securely.
Alternate Mounting, 30" deep table:
1. Adjust work surface mounting brackets (C) so flat top of
bracket is flush with long side of desk screen (A).
2. Attach work surface mounting brackets to underside of
work surface with wood screws (G, from hardware
pack) at desired location. No pilot holes are provided for
the alternate mounting location on the 30" deep table.
Tighten screws securely.
Mounting on nesting table:
1. Position mounting bracket (C) on spreader bar so lip on
mounting bracket is butted up against spreader bar.
2. Use / " power nutdriver to drive self-tapping screws (I,
1
4
from hardware pack) through mounting bracket and into
spreader bar. Tighten screws securely.