Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
WARNING
• Always wear eye protection with side shields marked to comply with ANSI Z87.1 along with
hearing protection. Failure to do so could result in objects being thrown into your eyes and
other possibly serious injuries.
• Do not use any attachments or accessories not recommended by the manufacturer of this
product. The use of attachments or accessories not recommended can result in serious
personal injury.
1. Filling Oil Tank with Bar and Chain
Lubricant
The pruning saw is not filled with oil at the time
of purchase. It is essential to fill the tank with oil
before use. Operating the saw without chain oil or
when the oil level is below the minimum mark will
result in damage to the saw. Chain life and cutting
capacity depend on optimum lubrication.
The chain is automatically lubricated with chain oil
during operation.
WARNING
• Do not smoke or bring any fire or flame near the
oil or the pruning saw. Oil may spill and cause a
fire.
a. Remove the battery pack from the pruning saw.
b. Clean the oil-tank cap (J) and the area around it to ensure that no dirt falls into the oil tank.
c. Position the pruning saw on its side on a firm, flat surface, so that the oil-tank cap is facing
up. Lift the cap tab (I) and rotate it counterclockwise to remove the cap (J).
d. Carefully pour the bar and chain oil into the tank (K). Fill to the bottom of the fill neck. Wipe
off any excess oil.
e. Replace and tightly secure the cap. Fold the cap tab.
f.
Place the saw upright and examine the oil level through the translucent plastic oil tank.
NOTICE:
• Use KOBALT® and TriLink® bar and chain oil for best results. It is specifically designed to
provide low friction and faster cuts.
• Never use oil or other lubricants not specifically designed for use on the bar and chain. This
can lead to a clogged oil system, which may cause premature wear of the bar and chain.
• Check the oil level frequently and fill the tank when the oil level falls below the minimum line.
Never operate the pruning saw if the oil is not visible.
• Do not use dirty, used, or otherwise contaminated oil. Damage may occur to the bar or
chain.
• It is normal for oil to seep from the saw when it is not in use. To prevent seepage, empty the
oil tank after each use and then run the saw for one minute. When storing the tool for a long
period of time, be sure that the chain is lightly lubricated. This will prevent rust on the chain
and bar sprocket.
To preserve natural resources, please recycle or dispose of oil properly. Consult your local
waste authority for information regarding available recycling and disposal options.
1
14
I
J
K
Publicidad
