Publicidad
Idiomas disponibles
Idiomas disponibles
4. Preliminary steps
Tools required:
• Drill and drill bit
• Phillips screwdriver
• Ruler and pencil
4.1 Mount configurations
The controller can be installed using one of three different mount
configurations:
Inside, Outside, or Middle.
Before you begin, determine which mount configuration is best for your
scenario.
1. Inside mount
• If the window shade sits inside the window frame and there is
enough space on the frame for the controller to be placed beside
the shade, use the inside mount position.
• This mount configuration requires the controller bracket to attach
to the inside of the window frame.
• Place the drilling template against the mounting surface to mark
the positioning of the bracket.
2. Outside mount
• If the window shade is positioned in a way where it covers the whole
window frame, or there is not enough room for the shade and the controller
to be placed side by side, use the outside mount position.
• This configuration requires the controller bracket to attach to the
wall on the outside of the window frame.
• Then place the side of the drilling template against the surface
and align before screwing it or taping the bracket in place.
3. Middle mount
• If the window shade does not have a window frame or wall
nearby, the controller can be mounted on a middle pillar between
two windows. This position is useful for areas such as boardrooms
with wall-to-wall windows and little to no mounting area in between.
• This configuration requires the controller bracket to attach to the
divisional structural elements between windows.
• Place the drilling template against the mounting surface to mark
the position of the bracket. For this mounting, it's recommended to
use the 3M adhesive sheet.
Ensure there is sufficient space around the controller
When deciding on the best mounting position, make sure that there is
three inches of space below the mounting bracket. This space is needed
as the controller must be plugged into a power source to operate.
Note: The minimum height for controller installation will be determined
by the chain length.
3"
minimum
Minimum space on bottom (left)
4.2 Installation procedure
Note: It is paramount that the installation is done correctly, according to
the instructions. If the mounting bracket is improperly placed, then
there is a high likelihood for the performance of the controller to be
degraded or the blinds to be damaged.
The following table describes four ways of installation: on the left of the
window, on the frame and on the wall. and to the right of the window,
on the frame and on the wall.
• After selecting the location to install the
controller, use the drilling template to
position the mounting bracket below the
chain or cord.
• Make sure to position the template so the
chain is tight and tensioned. Also, make sure
your chain or cord is not twisted and runs
straight down.
• If the controller is being installed on the
left of the window, use the L marking and
the R marking to install it on the right.
L
R
L
R
Minimum space on sides (right)
L
R
L
R
Publicidad
