Publicidad
Idiomas disponibles
Idiomas disponibles
The device comes with 3 different gears:
Cord gear – For string cords/small beads chains.
Medium chain gear – For small/medium beaded chains.
Large chain gear – For large, beaded chains.
• Remove the back cover, hook the chain or cord around the
selected cogwheel and snap the cover closed.
• Position the controller onto the mounting bracket from an angle,
making sure to line up the grooves with the lips on the mounting bracket.
• Pull the device downwards until your chain or cord is tensioned.
• For metal or plastic chains or beaded cords, do not pull controller
down too tight as it may wear down the device faster. Use enough
tension so that the cord doesn't wobble or slip. For strings, more
tension should be used.
4.5 Mounting the controller onto
the bracket
• On the back of the controller, towards the bottom, two grooves
run vertically near the left and right edges.
• Similarly, on the mounting bracket, there are two mounting lips.
• Position the controller flat up against the mounting bracket (both
lips should be inside the bottom-back grooves of the device).
• Then, slide the device downwards until the beaded chain or cord
loop pulls tight.
• Make sure the chain has enough
tension but avoid exerting
excessive pressure.
• To do so, you can use the preset
adjustment levels on the bracket.
A click will be heard to indicate
the different tension levels
being selected.
Please note that optimal tension
will depend on the type of shade
and the length of the chain.
• To power on the controller, plug it
in into any standard wall outlet,
making sure to place it near the
motorized window treatments you
plan to control.
• To release the controller off the
bracket, push the tab
underneath the device.
• The controller has now been
installed, turned on, and is ready
to be set up!
5. Initial calibration points
If this step is not completed, the controller will fail to operate.
Upper and lower setting
• With the blinds completely closed, press and hold the Stop
button for 8 seconds. The red LED will start blinking.
• Press the Up arrow until the required height is achieved, and
then press the Stop button again to save that setting.
• Calibration points can be reset as many times as needed by
restoring the controller to its factory default values.
• If you need to restore the device to factory settings, press and
hold the Up and Down arrows for 8 seconds until the LEDs
flash rapidly.
L
R
Publicidad
