Publicidad
Idiomas disponibles
Idiomas disponibles
A. Screws:
Note: When installing the controller on drywall or wood, we
recommend using the mounting screws. With plaster or concrete
walls, use the supplied screws and anchors.
• With a pencil, proceed to mark the pilot holes.
• Drill into the markings to bore the holes for the screws.
• Next, insert the screws through the two holes through the bracket.
Tighten until the bracket is firmly secured against the surface.
L
R
L
R
Inside
mount position
B. Double-sided tape:
Note: If your shades are heavy or take a
lot of force to open/close, use the
mounting screws and double-sided tape
when mounting onto drywall.
If you are installing controller on metal
or glass, use the double-sided tape and
do not attempt installation with the
screws.
• Clean the mounting area and peel off
the yellow liner of the tape and apply it
very carefully to the face of the
mounting bracket (side or back) that is
against the wall.
• Finally, peel the red liner of the tape off
and firmly press the bracket against the
wall for 10 seconds.
• Let the tape cure for at least one hour
to gain adhesive strength between
surfaces.
• Next, insert the screws through the two
holes through the bracket. Tighten until
firmly secured against the surface.
4.3 Setting the motor direction
• To set the motor direction, please ensure you have toggled the
switch either left or right.
• If the controller is mounted on the left of the blind, use the
supplied tool to toggle the switch to the left position, as marked
on the device.
• But if mounted the controller on the right, then it will have to be
switched to that side to match the direction of the mechanism.
• In this stage, the controller will turn on provided there is enough
battery power. If the controller does not turn on with battery
power, it will connect as soon as you plug it into a wall outlet.
L
R
L
R
Outside
mount position
3M
RIGHT
R
L
ON
To facilitate the operation of the unit, do not forget to manually
draw down the blinds before executing the next steps
4.4 Attaching the chain or cord to
the controller
NOTES:
• It is paramount to determine the correct wheel depending on the
chain or cord type you are using. Failure to do so may cause the
controller and the blind to malfunction.
• The controller works with continuous cord or chain loops, of the
sizes indicated in the chart below.
Cord /chain type compatibility
6
LEFT
ON
4.5
Publicidad
