osann Hero360 SL Manual De Instrucciones página 25

1 . Set the child car seat to the maximum reclining position and turn it until it is in rear-facing
seat position R.
2 . Set the age of your child on the RotationControl knob.
3 . Press the two side Isofi x connector buttons to extend the length of the Isofi x connectors.
4 . Fold out the support leg as described above.
5 . Guide the Isofi x connectors onto the Isofi x anchor points on the vehicle seat and ensure that
they lock into position.
6 . Push the child car seat in until it rests securely against the backrest of the vehicle seat. Ensure
that both Isofi x indicators are showing green.
7 . Adjust the height of the support leg and ensure that this is fully in contact with the footwell
of your vehicle.
8 . Ensure that the indicator on the support leg is switched to green.
9 . When placing your child in the child car seat, turn the car seat towards the car door for con-
venience.
10 . Unfasten the belt buckle on the child car seat and place the belts over the outside of the seat.
11 . Put your child in the child car seat.
12 . Adjust the height of the headrest as described above.
13 . Fasten the belt buckle again until you hear a click.
14 . Pull the front adjustment strap to tighten the belts.
15 . Ensure that the straps are not twisted.
16 . Turn the seat into the rear-facing position. Check that the child car seat is locked in this
position.
- 25 -
EN