Zipro Drift Manual De Uso página 12

2. Install the right and left pedal
Screw the left and right pedal (9L/R) to the crank (10). Screw the right pedal
bolt (9R) on clockwise. Screw the left pedal bolt (9L) counterclockwise.
NOTE! The right pedal is marked 'R' and the left pedal is marked 'L'.
See how to complete this step.
Scan the
3. Install the saddle
Fix the saddle (7) and a towel holder (36) to the saddle post (6) using flat
washers (33) and the nylon nut (34).
Next, fix the saddle post (6) to the main frame (1), securing it with the saddle
post knob (31).
NOTE! Do not exceed the maximum and minimum height on the post when
adjusting saddle post height.
NOTE! Before using the device, make sure the saddle is stable in the guide.
4. Install the handlebar column
Connect the computer sensor cable (17) from the main frame (1) to the
connecting cable (18) in the handlebar post (4).
Next, connect the resistance adjustment cable (16) to the other connecting
cable (16) as shown in the picture.
Slide the nut of the upper resistance adjustment cable (16) into the slot in the
post of the lower resistance adjustment cable (16), pull and tighten the upper
cable (16) and move the lower cable post (16) vertically. Cable nut should be
on the post as shown in the picture.
Insert the handlebar post (4) into the main frame (1) and fix it with bolts (19)
and curved washers (35).
See how to complete this step.
Scan the QR code and watch the video.
EN
12