LUCCI Air 210667 Instrucciones De Instalación página 4

Installation Instructions
BATTERY INSTALLATION
1 pcs 3V CR2450 battery is required to operate the remote control.
1. For first time use of the remote, remove the battery film before use. (Fig. 5a)
2. To replace a new battery, loosen the screw from the battery compartment cover (Fig. 5b).
Note: Screw do not come apart from the cover. Do not force the screw and cover apart.
3. Remove the battery compartment cover from the back of the remote to access the battery (Fig. 5c)
Battery film
Fig. 5a
Install the 3V CR2450 DC battery into the remote. Please make sure the polarity of the battery is correct. (Fig. 6)
Install the battery compartment cover back onto the remote and secure by re-tightening the screw.
PAIRING REMOTE & RECEIVER
NOTE: The remote and receiver will need to be paired after the installation of the ceiling fan.
NOTE: When two or more ceiling fans are installed in one location, please refer to the instruction on the next
page.
PAIRING REMOTE & RECEIVER – WHEN 1 CEILING FAN IS INSTALLED IN ONE LOCATION
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for the fan.
NOTE: Ensure power to the receiver is ON prior to pairing the remote with the receiver.
•
Turn OFF the mains supply to the fan by on/off wall switch.
•
Install the battery into the remote. Please make sure the polarity of the battery is correct. (Fig.6)
•
Turn ON the power to the receiver.
•
Within 60 seconds of switching the power ON to the receiver of the ceiling fan;
•
Press and hold the "
then release. During the process, the indicator light will flash slowly.
•
Turn ON the fan and change the speed of the ceiling fan via the remote to check the operation and successful paring.
•
If pairing has been unsuccessful, repeat these set of steps again.
4 | P a g e
" light button and " " 8 hours timer button on the remote at the same time for 5 seconds and
Fig. 7b
Fig. 5b
Fig. 5c
Fig. 6
v 1 . 0 ( 0 3 / 2 0 2 1 ) E U