Stahlwille Standard MANOSKOP 720 Nf/80 Manual Del Usuario página 37

3. Check to see that the shell tool is
properly attached.
4. To tighten counter clockwise, turn the
shell tool through 180° before
attaching to the torque wrench.
Exception: If you are using a ratchet
adapter, attach as „normal" to the
torque wrench and reposition the
square drive (see page 36).
Removing shell tools –
730/80
1. Insert a fine
punch into the
locating hole of
the shell tool
from outside.
Use the punch
to depress the
locking pin.
2. Now remove the shell tool.
Setting the desired torque
The torque level at which the wrench cuts
out is set by moving the scale against the
fixed mark. To do so, turn the smooth
running self-locking knob. Always
approach the desired torque setting from
a lower value.
Intermediate settings between two marks
on the scale can be estimated.
Proceed as follows:
1. With the 721 Nf/100 it is necessary
to remove the grip tube first (see
page 34). This does not apply to
other models.
2. Turn the knob
clockwise until
the scale shows
a value lower
than the desired
cut-off value.
3. Then turn the knob counter
clockwise, until the mark for the
desired cut-off value is in the middle
of the scale window.
37