Descargar Imprimir esta página

Stahlwille Standard MANOSKOP 720 Nf/80 Manual Del Usuario página 38

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 73
EN
4. Check the value again. If the setting
is wrong, return to 2.
Controlled counter
clockwise tightening
For reasons of accuracy, these torque
wrenches have been designed to work in
only one direction. The direction is
marked with an arrow.
Controlled counter clockwise tightening
is possible by turning the MANOSKOP
over.
For controlled counter clockwise
tightening using the MANOSKOP
720 Nf/80, 721 Nf/80 und 721 Nf/100 in
the turned over position, the square drive
must first be pushed through to the upper
side and refitted from the underside (see
page 36).
For controlled counter clockwise
tightening using the MANOSKOP
730/80, the shell tools have to be rotated
through 180°. Exception: If you are using
a ratchet adapter, attach it to the
MANOSKOP
Then push the square drive out through
the upper side and reinsert it from the
underside (see page 36).
Uncontrolled loosening of
nuts & bolts ...
..., for example during a tightening
operation, is possible if the
MANOSKOP
38
®
in the "normal" manner.
®
is turned over.
®
®
®

Publicidad

loading