Stahlwille Standard MANOSKOP 720 Nf/80 Manual Del Usuario página 44

EN
To adjust the wrench, you will need the
torque tester and an Allen key, size
2 mm. Proceed as follows:
1. Remove the two plugs using a sharp
object. Retain the plugs for later use.
2. To adjust the lower end of the range,
insert the Allen key in the hole nearer
to the handle. To adjust the lower
end of the range, insert the Allen key
in the other hole.
3. Turn the Allen key with great care
and very slowly. Turning in a
clockwise direction increases the cut-
out torque level, turning in the other
direction decreases it. The screws
will lock in any position.
4. Once you have made an adjustment
using one screw, check the effect by
testing the cut-off value on the torque
tester.
5. Repeat the adjustment of one or both
screws and the testing process until
the deviation has been
compensated.
6. Finally, do a thorough test again.
Proceed as described under see
„Checking the accuracy of the cut-off
value" on page 41.
If you cannot achieve adequate
correspondence between the triggering
values and the set values in this way, the
triggering mechanism is probably
defective.
Consult STAHLWILLE if this occurs.
44