Installation Tips - INVENTOR ΑΤΜ-25L Manual De Usuario

Installation tips

3) Ensure the filter is clean.
4) Place unit in vertical operating position and allow 2
hours before initial use in order to avoid malfunctions.
• Remove the filter components
• Remove the protective plastic
packaging of the filter prior to initial
use.
• Install the filter componenets
EN
1) Do not block or restrict the
airflow around the unit. Make sure
the air inlet exhaust grills are not
obstructed. Allow 30cm of clearance
around the unit and 40cm above.
2) Place the unit in an area where
the temperature levels will not
fall bellow 5ºC (41ºF) There is a
possibility the coils will collect frost
at temperatures that are under
5ºC (41ºF), which may result in low
performance.
(Working conditions: 5°C-35°C,
30%RH–90%RH).
5) Before the initial operation, please check,
if the water level switch, located within the
water bucket area, is in the right position.
9