Care And Maintenance; Care And Cleaning Of The Dehumidi Er; Troubleshooting Tips - INVENTOR P2 - 25L Manual Del Propietário

CARE AND MAINTENANCE

Care and cleaning of the dehumidifier
Turn the dehumidifier off and remove the plug
from the wall outlet before cleaning.
1. Clean the Grille and Case
Use water and a mild detergent. Do not use bleach
or abrasives.
Do not splash water directly onto the main unit. Doing
so may cause an electrical shock, cause the insulation
to deteriorate, or cause the unit to rust.
The air intake and outlet grilles get soiled easily, so use
a vacuum attachment or brush to clean.
2. Clean the bucket
Every few weeks, clean the bucket to prevent growth of mold,
mildew and bacteria. Partially fill the bucket with clean water
and add a little mild detergent. Swish it around in the bucket,
empty and rinse.
NOTE: Do not use a dishwasher to clean the bucket.
After clean, the bucket must be in place and securely
seated for the dehumidifier to operate.
3. Clean the air filter
Remove the filter every two weeks based on normal
operating conditions.
To remove the filter, pull filter outwards (See Fig.14).
Wash the filter with clean water then dry.
Re-install the filter,replace Bucket.
CAUTION:
DO NOT operate the dehumidifier without a filter
because dirt and lint will clog it and reduce
performance.
4. When not using the unit for long time periods
After turning off the unit, wait one day before emptying
the bucket.
Clean the main unit, water bucket and air filter.
Wrap the cord with the power cord buckle.
Cover the unit with a plastic bag.
Store the unit upright in a dry, well-ventilated place.
Fig. 14
10
Before calling for service, review the chart below.
Problem
,
Make sure the dehumidifier's plug is pushed completely into the
outlet.
Unit does not start
Check the house fuse/circuit breaker box.
Dehumidifier has reached its preset level or bucket is full.
Water bucket is not in the proper position.
Did not allow enough time to remove the moisture.
Make sure there are no curtains, blinds or furniture blocking the
front or back of the dehumidifier.
Dehumidifier does not
The humidity control may not be set low enough.
dry the air as it should
Check that all doors, windows and other openings are securely
closed.
Room temperature is too low, below 5 C(41 F).
There is a kerosene heater or something giving off water vapor
in the room.
The air filter is clogged.
The unit makes a loud
The unit is tilted instead of upright as it should be.
noise when operating
The floor surface is not level.
Frost appears on the
This is normal. The dehumidifier has an Auto defrost feature.
coils
Hose to connector or hose connection may be loose.
Water on floor
Intended to use the bucket to collect water, but the back
drain plug is removed.
ES, AS,P2,EC ,Eb and
These are error codes and protection code. See the CONTROL
E3 appear in the display
PADS ON THE DEHUMIDIFIER section.
Clean the filter of the pump.
The pump operation
Check that the pump hose is not kinked or blocked.
on light blinks at 1Hz
Empty the water of the bucket.

TROUBLESHOOTING TIPS

What to check
O O
11