Zycoo SL30 Guia De Instalacion página 4

Network Settings
1
Connect the power supply (or PoE) and the network cable.
2
After the device is started, you need to unscrew the grounding screw, press the white but-
ton on the PCB board, then release the button and the device will broadcast the IP ad-
dress, DHCP function is enabled by default. If no address is obtained, the default login IP
address will be 192.168.1.101.
3
Enter the device IP address in the address bar of the browser to enter the device login in-
terface. The default user name and password of the device are both admin.
Mechanical Installation
1
Use an drill to drill 2 holes on the mounting wall according to the size of the equipment in-
stallation holes, and the size of the plastic anchor is M10*50mm.
2
Insert a plastic anchor into each of the mounting holes and use rubber hammer to tighten
the installation of the anchors.
3
Install the mounting bracket to the mounting holes using the M6*50mm screws.
1
English
Installation Pa
(Figure 1)
Front View