Zycoo SL30 Guia De Instalacion página 6

6
After the installation is complete, plug the network cable (PoE can be used) directly into
the network port.
7
If used outdoors, it is recommended to use the provided waterproof plug for the network
cable, pass the network cable through the waterproof plug and connect it to the network
port and then tighten it.
8
If the PoE is not used to supply power, the DC power supply can be used as well. And
you need to plug the power cord into the power connector.
9
If connecting cameras, alarm lights and other equipment, you need to connect the con-
necting wire to the J2 connector terminal.
10
If connecting an audio source device, you can connect it to the audio input interface.
Note: The installation direction of the device can be reversed (the outlet of the wire is
downward), but such an installation angle can only be adjusted by three angles.(0,8,16)
Audio Input
Reset Facto
The SL30 network column speaker can only be restored to the factory settings through the sys-
tem software. Please log in to the device background system to restore the factory settings.
3
Schematic diagram of wiring harness
Defaults