MoMi ESTELLE Manual De Usuario página 8

5. The rear wheels (10) are mounted in the same way as for the front wheels. Follow step no.4 (fig no
4 & 5).
6. To install the seat bar (5), grasp it with both hands and align it with the connectors on both sides of
the wheelchair. Press the headband into the connectors until you hear a click. Pull the headband to
make sure that it is properly seated (Fig. 6).
PRODUCT FEATURES:
1. To adjust the footrest (7), press both the adjustment buttons under the footrest (fig. 7 and 8).
2. The backrest of the trolley (6) can be adjusted to various positions, depending on current needs. To
adjust the backrest to a sitting position, squeeze the button on the back of the backrest and slide it
up towards the backrest. To adjust the backrest to a lying position, squeeze the adjustment button
and pull it downwards against the backrest (fig. 9 and 10).
3. When the brake (8) on the rear wheels is as shown in figure 11, it means that it is not blocked. In
order to block the wheels, press the brake with your foot and set it in the position shown in figure 12.
4. The canopy (1) can be adjusted to many different positions as needed. To fold the hood, grasp
the front of the hood and push it towards the push handle. In order to unfold the canopy, do the
opposite, pull the edge of the canopy in the direction opposite to the handle. The canopy can be
enlarged by an additional part by unfastening the zip fastener and pulling the canopy forward. To
lock the zipper and reduce the area of the sunshade, first fold it down by pushing towards the push
handle (fig. 13 and 14).
FOLDING:
1. Always fold the canopy before folding the product (fig. 15).
2. To fold the wheelchair, release both locks on the push handle (3). Pull the fold button (2) on the
top of the push handle to the left and simultaneously press the button under the push handle.
When the lock is released, push the handle down, the cart will fold up and the locking latch will lock
automatically (fig. 16 and 17).
3. To transport the wheelchair easily, pull out the pull bar which is under the footrest (fig. 18 and 19).
SEAT BELTS:
• The product has 5 – point seat belts. To fasten the seatbelts put both shoulder buckles on top of
the side belt buckle and then place combined shoulder and side straps in the crotch belt buckle. To
unfasten the seat belts press the central button and unbuckle all the clasps (fig. 20 and 21)..
• The straps can be adjusted (fig. 22) to fit the child properly, but be careful that the child is not too
tightly compressed and can breathe freely.
• When fastening the seatbelts, make sure that the child's hands are not near the buckle.
• Attention! Always use a clasp system.
PRODUCT MAINTENANCE:
• Periodically check the technical condition of the trolley for damage or missing parts.
• Stop using the wheelchair if any part is missing or damaged.
• The product should be cleaned with a damp cloth with a mild soap solution.
• If the product frame has been exposed to salt solution, clean the product as soon as possible with a
8 EN