Wayscral KICKWAY E1 Instrucciones De Uso página 75

G. Charging procedure
Recharge the scooter's battery according to the following procedure:
The battery can be charged using a standard power outlet.
•
Insert the charger plug into the scooter battery (charging
•
connector) by lifting the silicone cover over the charging
connector on the front right side of the footrest.
Make sure that the charging connector is dry and plug the power
•
cable of the charger into a nearby power outlet.
When charging, the LED on the charger will be red to show that
•
it is working correctly. When it turns green, it means that the
battery is charged.
To finish charging, you must disconnect the power plug and then
•
the plug connected to the battery. Finally close the cap of the
battery socket.
Unplug the mains plug
•
IMPORTANT:
Charging for too long may shorten the life of the battery. Do not
•
leave your KICKWAY E1 charging overnight.
Keep the charging environment clean and dry.
•
Do not charge the battery if the charging plug is wet.
•
Lift the rubber flap.
75/269
Plug the power
When charging is
adapter into the
complete, replace
charging port.
the rubber flap.