Wayscral KICKWAY E1 Instrucciones De Uso página 58

II. Unpacking and assembling the scooter
1. Open the box and take out all the parts (do not throw away the
packaging as you will need it if you return the product)
2. Raise the stem by holding the handlebars.
3. Raise the folding lever and ensure that it is securely locked.
4. Insert the handlebars into the stem using the placement guides
and the cable connection device.
5. Place the holes of the locking hook opposite the holes of the stem
and handlebar.
6. Tighten the 2 screws (5 N.m) on each side using the 3 mm key
provided.
7. Press the brake lever and insert the brake cable head into the
brake lever holder.
8. Pass the cable through the slot in the brake lever until the sheath
reaches the brake lever stopper. It is necessary to pull on the
sheath to perform the operation.
9. Check the brake's functioning by operating the lever. The brake
caliper must apply pressure to the brake disc to prevent the wheel
from turning.
10. Follow steps 7, 8 and 9 for each brake lever. Check that the left
lever operates the front wheel brake system and the right lever
operates the rear brake system.
58/269