Publicidad
Idiomas disponibles
Idiomas disponibles
English
Changing the temperature scale
Make sure the thermometer is turned off . Press and
hold down the "start" button . Keep holding down
the "start" button and after about 3 seconds the
display will start to cycle between temperature
scales (°F or °C) .
Release the start button when the desired scale is
shown . This will reset the thermometer to the new
temperature scale .
Replacing the battery
The thermometer is supplied with one 3V Lithium cell battery (type
CR2032) . Insert new battery when the low battery symbol appears
on the display .
The battery door design is
intended to prevent a small child
from easily opening the battery
door to address a possible choke
hazard . Open the battery
compartment by inserting a
narrow pointed object such as a ball point pen or paperclip into the
small hole above the battery door (8) . While pressing into the hole
slowly slide back the battery door with the other hand .
To close battery door align the tabs along the side of the battery
into the battery compartment and slowly slide back into position
until the door clicks into its locked position .
Do not mix alkaline, standard, or rechargeable batteries .
Calibration
This product has been calibrated at the time of manufacture . If
used according to the use instructions, periodic calibration is not
required . If at any time you question the accuracy of temperature
measurements, please contact Consumer Relations .
11
Publicidad
