Using Your Espresso Machine
NOTE: Make sure the control knob is always in the neutral position when NOT using the
Steam and Hot Water functions.
NOTE: The steam wand swivels for easier use. DO NOT pull on steam wand.
CAUTION
hot steam, do not touch liquids or steam wand during or after steaming. Do not
remove pitcher until steaming is complete. Hold milk pitcher by the handle
Steam
The Steam function can be used to steam milk and other liquids.
See the Tips section for techniques and recipes.
1. Turn the control knob on the front of the espresso
machine to Steam. Ensure the steam wand is
pointing towards the drip tray as it will clear out
some water during preheat. Once steam starts to
come out, switch the knob to neutral position and
quickly insert the wand into the milk. Proceed with
steaming process by turning the control knob back
to Steam.
NOTE: If there is a delay longer than a few seconds between heating and steaming, the
heating will shut off and need to be repeated.
2. Turn the control knob back to neutral when complete.
NOTE: Use a hot, wet cloth to wipe off steam wand after every use. It is also
recommended to purge the steam wand immediately after every use by quickly
turning Steam back on for a short time.
NOTE: After every steam cycle your machine will automatically release internal
pressure as it is cooling down by slowly pumping access water and steam into the
drip tray. Steam coming out of the drip tray is normal during this process. DO NOT
remove the drip tray until the process is complete.
Hot Water
NOTE: If using the Hot Water function after steam, allow the machine to dispense excess
steam before using this function per note above.
NOTE: Hot water volume and temperature can be adjusted via the SmartHQ app.
1. Place your desired cup or milk pitcher provided under the steam wand.
2. Turn the control knob on the front of the espresso machine to Hot Water.
3. Fill your cup to your desired amount. If the dispense is not stopped manually by user,
the machine will continue to dispense until a programmed volume is set.
4. Turn the control knob back to neutral when complete.
To avoid possible burns to body parts and/or other injury from
12
.