Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Problem
Appliance does not
work/does not turn
on
Coffee is not hot
enough
Water/Steam does
not come out of
steam wand
Coffee does not come
out of portafilter
Espresso shot has no
crema
Appliance takes too
long to heat up
Water tank is empty
but "Add Water" alert
does not show up
Cause
No power is connected to the appliance
Cup is not preheated
Excessive scale has built up
Empty system function may have been
used
Pump airlock (air in the water pump)
Something is blocking the steam wand
Coffee is tamped too tightly in the
portafilter or gounds are too fine.
The dose of coffee is too high
Coffee grounds are too coarse
Coffee beans are not fresh
Excessive scale has built
Water sensor is detecting water on the
outside of the water tank
Solution
■ Check cable and plug are connected
to power and press the "on" button
■ Check GFI plug
Run hot water in the cup prior to
brewing to warm up.
Or place your cup on top of the machine
prior to use.
Descale the appliance as directed on
page 15.
Run the hot water function until water
starts dispensing
Run the hot water function until water
starts dispensing
Run the hot water function until water
starts dispensing
Empty portafilter and try again with a
larger grind size or less force while
tamping.
Use a coarser grind size or less dosage.
Adjust coffee bean grind size to a finer
setting during grinding operation or use
a double layer filter provided.
Change or use appropriate coffee beans
Descale the appliance
■ Wipe the water tank and back area of
the machine completely dry.
■ Avoid pouring water directly into the
water tank. It is recommended to pull
out water tank, fill, then replace in the
machine.
18
Publicidad
