TEXA TX-i40 Manual De Instrucciones página 20

ENG
1. General Warnings
This manual, together with the rest of the hardcopy/digital documentation, is considered an integral part of the product.
Ensure that all persons who use the product and authorised maintenance personnel can easily locate it for consultation when required.
WARNING
Do not use the regulator for functions other than those described; do not use it as a safety device.
CAUTION
Check the limits of application.
CAUTION
Isolate the power to the device before commencing any maintenance work.
NOTICE
Contact TEXA INDUSTRIES S.r.l. immediately in writing in the event of faults or malfunctions.
NOTICE
TEXA INDUSTRIES S.r.l. shall bear no liability in the event of faults or malfunctions due to failure to comply with the instructions given.
2. General Information
The TX-i40 is a microcontroller suitable for applications on cooling units at normal temperature; it is composed of an electronic control board installed in
the evaporation zone and a display for managing and configuring the device.
2.1 TX-i40 Display Description
The following drawing shows the layout of the TX-i40 display:
The following table illustrates the meaning of the parts of the TX-i40 display:
Part Description
1 Display
2 ON/Stand-by key
DOWN key
3
4 UP key
5 SET key
6 Seal
7 Terminal board for quick connection of the power supply and the INTRABUS port
2.2 Dimensions and Installation
The following drawing illustrates the dimensions of the TX-i40 display; the dimensions are given in mm (in).
20