Descargar Imprimir esta página

EAS ELECTRIC EMR451 Manual De Instrucciones página 28

Ocultar thumbs Ver también para EMR451:

Publicidad

Idiomas disponibles

Idiomas disponibles

3. MAINTENANCE OF REFRIGERATOR
3.1 Overall cleaning
Dusts behind the refrigerator and on the ground shall be timely cleaned to improve
the cooling effect and energy saving.
Check the door gasket regularly to make sure there are no debris. Clean the door
gasket with a soft cloth dampened with soapy water or diluted detergent. The interior of
the refrigerator should be cleaned regularly to avoid odor. Please turn off the power
before cleaning interior, remove all foods, drinks, shelves, drawers, etc.
Use a soft cloth or sponge to clean the inside of the refrigerator, with two
tablespoons of baking soda and a quart of warm water. Then rinse with water and wipe
clean. After cleaning, open the door and let it dry naturally before turning on the power.
For areas that are difficult to clean in the refrigerator (such as narrow sandwiches, gaps or
corners), it is recommended to wipe them regularly with a soft rag, soft brush, etc. and
when necessary, combined with some auxiliary tools (such as thin sticks) to ensure no
contaminants or bacterial accumulation in these areas. Do not use soap, detergent, scrub
powder, spray cleaner, etc., as these may cause odors in the interior of the refrigerator or
contaminated food.
Clean the bottle frame, shelves and drawers with a soft cloth dampened with soapy
water or diluted detergent. Dry with a soft cloth or dry naturally. Wipe the outer
surface of the refrigerator with a soft cloth dampened with soapy water, detergent,
etc., and then wipe dry.
Do not use hard brushes, clean steel balls, wire brushes, abra-
sives (such as toothpastes), organic solvents (such as alcohol,
acetone, banana oil, etc.), boiling water, acid or alkaline items,
which may damage the fridge surface and interior.
Boiling water and organic solvents such as benzene may
deform or damage plastic parts.
Do not rinse directly with water or other liquids during
cleaning to avoid short circuits or affect electrical insulation after
immersion.
3.2 Defrost
Refrigerator shall be manually defrosted.
Disconnect the plug from the wall socket, open the door and remove all the food to a cool
place.
It is recommended to remove the frost by a plastic scraper, or let the temperature rise
naturally until the frost melts. Then wipe away the remaining ice and water, and plug in
socket for switching on the freezer.
Other mechanical devies or other means shall not be used to accelerate except
those recommended by the manufacturer. Do not damage the refrigerant circuit.
3.3 Stop using
Power failure: Foods can be preserved for a couple of hours even in summer in case of
power failure; it is recommended to reduce the frequency of opening door and do not put
fresh food in the refrigerator.
Long time nonuse: Please unplug the refrigerator left unused for a long time for cleaning.
Keep the door open to avoid the bad odor.
Moving: Do not turn upside or vibrate the refrigerator, the carrying angle can not be greater
than 45º. Do not hold the door and hinge when moving this unit.
Continuous operation is recommended when the refrigerator is started.
Please do not stop the refrigerator under normal circumstances so as not to
affect the refrigerator's service life.
Please unplug the refrigerator for defrost and cleaning.)
11
V.3

Publicidad

loading