IKA RV 10 control Instrucciones De Manejo página 34

Setting up
Drive RV 10 control
ATTENTION! Loosen transportation lock (fig. 4a)!
 Hold the lift with your hand on the height position and
remove the thumb screw on the back of the appliance (A).
 Once the transportation lock has been removed, the lift moves slowly to
its upper end position. The distance is approx. 140 mm.
 Connect the device to the power supply (B) using the supplied power
cord (B).
Adjustable base (fig. 4b)
Mounting the Woulff bottle (Fig. 5)
 Fit the hose connecting piece (C) on the left side of the lift.
 Mount the holder (D) onto the hose connecting piece (C).
C
 Insert the bottle and attach the supplied hose connectors to the bottle
(fig. 6).
 Remove the clamping device for the angle setting of the rotation drive
 Set the drive at an angle of approx. 30° (fig. 7).
Fig. 4a
 Then secure the rotation drive from being accidentally
Heating bath HB 10
CAUTION! Refer to the chapter entitled "Commissioning" in the heating
bath instruction manual!
 Place the heating bath on the stand of the rotation drive and push it
Fig. 4b
Note: Data is exchanged between the drive unit and the hea-
ting bath by means of an infrared link (F). Please note that reliable commu-
nication is only guaranteed when the infrared beam has clear line-of-sight
to the detector.
Glassware
Fig. 5
 Release the locking device on the steam pipe by turning it 60° counter
D
Fig. 6
on the right side of the lift by rotating the knurled screw counter clock-
wise (gently press and rotate the knurled screw (E) at the same time to
move it further in or out).
turned by tightening the knurled screw in a clockwise direction.
into the left position (fig. 8).
clockwise (G), (fig. 9).
E
Fig. 7
F
Fig. 8
G
H
Fig. 9
34