Costway OP70367 Manual Del Usuario página 16

EN
Drilling the Bolt Holes
1. Now that you have a straight level line
across the wall with the locations of the wall
brackets and their bolt holes marked, you can
drill holes to mount the brackets.
2. Using a 14mm masonry drill bit, drill the first
bolt hole approximately 8 cm deep, as shown in the diagram. This must be drilled
through solid brick or concrete to offer the necessary support for the awning.
3. Drill the remaining holes exactly as in step 2.
Failure to securely fasten all the brackets to the wall could result in the collapse
of the awning and cause personal injury or death.
All bolt holes must be aligned vertically and horizontally to ensure that the awning hangs
straight.
Double check alignment before drilling if you are not certain.
The diameter and depth of your mounting holes must be the same size as the expansion
bolts.
Preparing for Mounting
① Now that all of your holes are drilled, then insert the expansion bolts.
② It may be necessary to drive the bolts in with a wooden (or other non-metallic) mallet.
If a mallet is necessary for installation, we recommend placing the nut on
the screw (loosely) before hammering to avoid damaging the bolt threads.
③ Make sure that the bolts are firm in place, yet let them stick out of the wall
approximately 2.5 cm or less-enough that the wall bracket can be installed onto them.
Firmly tighten the bolts with a 19 mm hex key. It is best to use the hex key with a closed
end rather than an open end to avoid damaging the nut, should it slip.
M10X80MM
Expansion bolt
16
WARNING
Spring washer
bolt
washer
Drill 8 cm deep
Bolt