Parkside PAS 10 A2 Manual De Instrucciones página 22

Idiomas disponibles

Note: Remove all packaging materials from the product.

Note: Protect delicate surfaces before setting up the product.

26 GB/IE

3561_2010_par_LED-Arbeitsstrahler_A6_content_OS.indd 26

Never leave the product unattended whilst in operation. Excessive

heat can result in fire.

The LED module is not dimmable.

Do not look directly into the light source (illuminant, LED etc.). Do

not look into the light source (illuminant, LED, etc.) with an optical

instrument (e.g. magnifying glass).

A shattered protective covering must always be

replaced.

Never aim the LED light beam at reflective surfaces or at people or

animals. Failure to observe this instruction can lead to eye injuries

and / or loss of sight in people or animals. Even a weak LED light

beam can cause eye damage.

Disconnect the product from the mains supply whenever you want

to set it up in a different location.

The product is not suitable for use as room lighting.

Before use

Fully unwind the mains cable (remove the cable tie).

Loosen the knurled screw

turning it anticlockwise, in order to move the fold-out stand

the desired position.

Then re-tighten the knurled screw

Set up the product in the desired location.

Note: The lamp head can be continuously tilted.

on the side of the product by

by turning it clockwise.

24.03.21 11:3