Stealth Products UniLink Manual De Usuario página 7

Operating Laterals
To adjust links (B) and (C):
1. Slightly loosen the M5 x .8 x 25mm
Socket Head Screws at (B) and (C).
2. Set desired angles and re-tighten screws
with a 4mm Hex Wrench.
To adjust pad position:
1. Slightly loosen the two M6 x 1.0 x 16
mm Button Head Screws (D) and slide
the pad to the desired position.
2. Re-tighten screws. Do not over-tighten.
Standard Track Mounting
To install and adjust standard track mounting:
1. Insert the M6 x 1.0 x12mm Button
Head Screws (A) through the counter
bored holes (B) and into the threaded
holes of the Universal Track Nut (C).
2. Set desired position and tighten screws
with a 4mm Hex Wrench.
3. To adjust the lateral on the track,
loosen the screws and slide to the new
position. Re-tighten the screws.
The laterals should only be installed and/or adjusted
EN
CAUTION
by a qualified healthcare professional.
B
C
D
A
Installation
C
B
2