Stealth Products UniLink Manual De Usuario página 8

Installation
Standard Cane Mounting
To install and adjust standard cane mounting:
1. Insert the M6 x 1.0 x 20mm Button Head Screws (A) into the male tube
clamp (B) through the counter bored holes and into the female side of
the tube clamp (C).
B
A
2. Attach lateral by using M6 x 1.0 x 12mm Button Head Screws (D) and
mounting directly to the female side of the cane clamp. Tighten with
an M4 Hex Wrench.
3. To adjust the lateral on the cane, loosen the M6 x 1.0 x 20mm Button
Head Screws (A) and slide the clamp to desired position. Tighten the
screws.
All Season Mounting
To install and adjust the All Season mounts:
1. Attach the All Season bracket to the chair by using the M6 x 1.0 x 12mm Flat
Head Screws (A). Tighten with a 4mm Hex Wrench.
2. Use the M6 x 1.0 x 12mm Button Head Screws (B) to directly mount the lateral
to the all-season bracket. Tighten with a 4mm Hex Wrench.
3. Depress the red button (C) and slide the mount to make lateral adjustments in
half-inch increments.
3
C
B
D
C
A
EN