Abask Q40S Manual Del Usuario página 11

first, then route the wire from front to back along the vehicle roof,
and install the rear camera at the rear of the vehicle.
8.Adjust the device position：Loosen the knob on the right hand
side of the mounting bracket,and adjust the vertical and
horizontal angle of the camera.Tighten the knob to lock the
position of the camera.
9.Start the engine and check if the machine has been installed
correctly.
3.2.1 Rear camera
1. Rear camera waterproof.
2. You can install it on the rear vehicle's windscreen ① or near
the license plate ②.
3.2.2 Reverse Parking Assistance
The back up camera with guide lines assists you safe parking by
connecting the positive terminal from the reverse lights.
NOTE：①The screen is small for parking assistance.② No need
to connect the red wire of rear camera with the reverse lights if
you don't want rear guidance when put the car in reverse gear,
and the dash cam will still record both front and rear.
3.3 Powering the dash cam On /Off
3.3.1 Auto Power On/Off
When the Car DVR is correctly installed and connected to your
vehicle's 12v power supply,the Car DVR will automatically power
up and start recording when the vehicle accessories are
activated.
3.3.2 Manual Power On/Off
(1) Manual Power On
Hold the Power button on the right side of the Car DVR until the
6