Publicidad
Idiomas disponibles
Idiomas disponibles
G-Sensor (Gravity Sensor)to decrease the number of triggers
caused by normal driving.It's better to set G-Sensor to "Medium"
to avoid too many useless locked videos.
Parking Guard: It's used to protect your car after parking. With
this function on, after you stop the car and camera turns o,it stays
standby. when camera detects shock and collision,the camera
will sense motion and automatically begin recording, then shut
down automatically.
NOTE:
To set Park Monitor Mode,follow the instructions below.
1.Ensure that the Car DVR is not recording.
2.Press the[M]Button to enter the Video Menu.
3.Press the [UP] or [DOWN] button to select the Parking Mode
setting option,select [OK] to confirm and press the [OK] Button.
4. Please buy "Dash Cam Hardwire Kit", the interface is mini
USB, Specification: 5V / 2A. Then connect the Car DVR to the
ACC fuse box of the vehicle, to continuously power the Car DVR.
4.1.4 Setting System Menu
Display Protection:Timing can automatically turn off the display
screen, so that the product can work under extremely low power
consumption. There are four modes of "Off/30 seconds/1
minute/2 minutes" in the "Screen Saver" of the system menu.
Choose "1" Minutes" means that it will enter the power saving
mode after 1 minute of power on, and turn off the display.
Option:Off/30 seconds/1minutes/2 minutes, Set the time it takes
for screen saver to be activated .It can also be turned off.
Auto Power Off: Set the time for the Car DVR to automatically
shut down to save power. The Car DVR will automatically shut
down when it is in standby for the set time. (Off/1min/3min/5min)
Frequency: 50Hz/60Hz.
Beep Sound:The Key beeps setting is used to turn Off or On the
beep that indicates a key press.
Language:Set the language for the dash cam.
Date/Time: Set the time and date, then press the [OK] button to
confirm/change, and press the [☰] button again to exit the time
setting.
Fill light: Turn on the fill light on the back of the camera. The
default is Auto. The fill light will automatically turn on to provide
light source for the recording of the car recorder in the dark
environment.
Format:Completely delete all files in the storage card.
Default Setting：Return menu setting Defaults.
Version: The firmware version of the car recorder.
4.2 Photo Mode
Press the [OK] Button to stop the Car DVR from recording.(no
red dot flashing on the screen)then press the mode [M] button to
enter the photo mode. In the photo mode, press the [OK] button
to take pictures and save.
NOTE:
1.Photo Mode cannot be accessed while the camera is recording.
10
Publicidad
