Makita LM001J Manual De Instrucciones página 16

When carrying the mower, hold the rear grip and the
lower holding part at the front of the machine with two
people as shown in the figure.
1
Fig.35
► 1. Lower holding part 2. Rear grip
Storing
CAUTION:
When putting the machine in the
upright position, place the machine on a flat and
stable surface. If the machine is placed on an unsta-
ble surface, the machine may fall over and cause an
injury.
Store mower indoors in a cool, dry and locked place.
Don't store the mower and charger in locations where
the temperature may reach or exceed 40 °C (104 °F).
1. Remove the battery cartridge and lock key.
2.
Turn the knob 90° while pulling the knob on the lower
handle to release the locking pin. Perform the same proce-
dure on the other side, and then fold the handle.
Fig.36
► 1. Knob
2
1
16 ENGLISH
NOTE: Supporting the handle makes it easier to
release the locking pin when pulling the knob.
3. Turn the knob on both sides 90°. Make sure that
the knobs are securely fixed.
1
Fig.37
► 1. Knob
NOTICE:
Be careful not to pinch the cord when
folding the handle.
4.
Loosen the thumb nuts on both sides, and then
fold the upper handle as shown in the figure.
1
Fig.38
► 1. Thumb nut 2. Upper handle
5. Place the machine in the upright position.
NOTE: When putting the mower in the upright posi-
tion, do not hold the handle only, but hold the mower
body and handle.
2