Panasonic EY74A2 Manual De Instrucciones página 15

Speed Control Function
Setting the maximum speed.
1. Press the speed setting button and select a speed.
The speed changes to H, M, L and OFF (the light is off) in this order.
2. Select OFF to release it.
Display Low mode
H Approx. 300 min
M Approx. 200 min
L Approx. 150 min
OFF Ordinary speed
18 V Approx. 470 min
14.4 V Approx. 400 min
• Default setting: OFF
• The speed is the same using either 14.4 V or 18 V when H, M, L settings are selected.
• If a high mode is chosen, the speed is set as the table above.
3 Mode LED Light
Press the light button to select illumination
setting.
Illuminated - Constant
Select by pressing lamp button light
will activate when trigger is pressed.
It will then stay illuminated for
approximately 5 minutes even if tool
is not used but will then switch off
automatically to save power.
Illuminated - On trigger
By pressing the lamp button again,
the mode will move to illumination
upon the pressing of the trigger
only. Will switch off when trigger is
released.
Off
The light illuminates with very low current,
and it does not adversely affect the perfor-
mance or its battery capacity.
CAUTION:
• The built-in LED light is designed to
illuminate the small work area tempo-
rarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
(rpm)
-1
(rpm)
-1
(rpm)
-1
(rpm)
-1
(rpm)
-1
CAUTION: DO NOT STARE INTO
BEAM.
Use of controls or adjustments or perfor-
mance of procedures other than those
specified herein may result in hazardous
radiation exposure.
Battery Level Indicator
Press the battery level button.
Battery level indicator shows battery level
in three levels while pressing the button.
NOTE:
The indicator will not show the battery
level when the button is pressed in the
following cases.
• The tool is powered off.
• Just after attaching the battery pack
• The main unit or battery level button is
not operated for approx. five minutes.
Press the battery level button again
after depressing the trigger switch.
• If the battery temperature is high, stop
the operation and wait until the battery
temperature is low.
- 15 -
High mode
Approx. 1000 min (rpm)
-1
Approx. 670 min (rpm)
-1
Approx. 500 min (rpm)
-1
Ordinary speed
18 V Approx. 1580 min
14.4 V Approx. 1350 min
Indicator Battery status
Fully charged
3 lamps
or high charge
illuminated
level
EN
(rpm)
-1
(rpm)
-1