Panasonic EY74A2 Manual De Instrucciones página 16

Indicator
EN
2 lamps
illuminated
One lamp
illuminated
3 lamps
flashing
This battery level function is only a guide
and indication may change due to the
condition of the battery or ambient
temperature.
Excessive (complete) discharging of
lithium ion batteries shortens their service
life dramatically. The driver includes a
battery protection feature designed to
prevent excessive discharging of the
battery pack.
Bit-locking Function
1. With the trigger switch not depressed
and a screwdriver bit locked in place,
the tool can be used as a manual
screwdriver (up to 22.6 N•m,
230 kgf•cm, 199 in•lbs).
There will be a little play in the chuck,
but this is not a malfunction.
2. This feature is handy for tightening
screws that require more torque than
the maximum torque of the driver
(position on the clutch), for confirming
the tightness of a screw or to loosen an
extremely tight screw.
Battery status
Approx. 60%
remaining
Low level
- Will require
charging soon
Empty
- Immediate
charging
required
- 16 -
Changing the Belt Hook Location
Side [Fig.8]
The belt hook can be attached to either
side of the unit.
1. Removing the hook
(1) Remove the nut.
(2) Draw out the hook.
2. Attaching the hook to the other side
(1) Insert the hook in the other side.
(2) Tighten the nut fully so that it
securely fastened.
WARNING!
• Be sure to attach the belt hook securely
to the main unit with the screw firmly
fastened. When the belt hook is not
firmly attached to the main unit, the
hook may disconnect and the tool may
fall. This may result in an accident or
injury.
• Periodically check screw for tightness.
If found to be loose, tighten firmly.
• Be sure to attach the belt hook firmly
and securely onto a waist belt or other
belt. Pay attention that the tool does
not slip off the belt. This may result in
an accident or injury.
• When the tool is held by the belt hook,
avoid jumping or running with it. Doing
so may cause the hook to slip and the
tool may fall. This may result in an
accident or injury.
• When the tool is hooked onto the waist
belt by the belt hook, do not attach
driver bits to the tool. A sharp edge
object, such as a drill bit, may cause
injury or an accident.
Warning Functions
(1) Overheat Warning
Off Illuminated:
(normal Overheat
operation) (motor)
Flashing:
Overheat
(battery)