Toto Vivian TL220DDH Manual De Instrucciones Y Del Propietario página 4

INSTALLATION PROCEDURE - Valves
1. Thread a mounting nut to the bottom
of the valve. Place a washer and gasket
as shown.
NOTE: the hot water valve has a red
marking on side of body.
2. Pass the valve up through the
installation hole.
Insert the gasket and fasten the
collar to the valve body until it
stops.
3. Fasten the valve by threading the
mounting nut up the valve until hand
Gasket
tight. Tighten the retaining screws
equally to secure.
Washer
Do not overtighten!
Mounting
Nut
4. Repeat steps 1-3 for remaining valve.
NOTE: Hoses to connect valve inlets to water supply lines not included.
INSTALLATION PROCEDURE - Spout
5. Place O-ring under spout.
Pass the supply hoses and
mounting stud through the
mounting hole until the spout
comes to rest.
Gasket
Washer
Mounting
Nut
Collar
Mounting
Mounting
Screws
Screws
Gasket
4
Gasket
Gasket
(Rubber)
(Rubber)
Washer Washer
(Metal) (Metal)
Mounting
Mounting
Nut
Nut
Collar
Collar
Gasket
Gasket
Spout
O-ring
M