Toto Vivian TL220DDH Manual De Instrucciones Y Del Propietario página 5

INSTALLATION PROCEDURE - Spout
6. Orient the spout as needed. From
below the mounting surface, place
the gasket and washer over the
mounting tube as shown.
Fasten by threading the mounting
nut up the tube until
hand tight. Tighten the retaining
screws equally to secure.
Do not overtighten!
7. Connect each hose to the side port
of each valve. Tighten with wrench.
NOTE: If wrapping the hose(s) in
a loop is needed, be careful not to
crimp the hose at any point as this
could restrict the water flow.
INSTALLATION PROCEDURE - Handles
8. Orient handle assembly and lower
onto the exposed portion of valve until
engaged. Rotate the base (dome) of the
handle assembly to fasten it to the valve.
Repeat for other handle assembly.
NOTE: If handles do not line up exactly
as desired, remove handle from valve
and reinstall one (1) notch over (on valve).
Fine adjustment may be done by slightly
rotating valve from underneath installed
surface.
9. Insert the drain lift rod through the
opening in the spout.
5
Mounting Tube
Gasket (rubber)
Washer (metal)
Mounting Nut
Handle Assembly*
Valve
Drain Lift Rod