Publicidad
Idiomas disponibles
Idiomas disponibles
Prepare the Hood
1 ] If present, remove all protective polyfilm from the hood and/or parts.
2 ] Remove 7" Round Duct Plate from top/back of hood (see illustration below). Remove the
adapter/damper from back of hood (see illustration below). Keep the screws for further use.
7" ROUND
DUCT
PLATE
2 SCREWS
3 ] Using the finger cup, remove the grease filters from the hood by pushing down
filters out
.
4 ] Using a 11/32" nutdriver or socket, remove the lock nut retaining the flange of the right cover
plate (shaded part on illustration below) to the inner back of hood (see inset). Remove the left
cover plate retaining screws (7 screws), then set the blower cover along with its screws and
nut aside.
B
C
5
4
6
1
7
BACK OF HOOD
LOCK NUT
2 SCREWS
and tilting
3
2
9
Publicidad
