Publicidad
Idiomas disponibles
Idiomas disponibles
MWE-650-4DSM.book Seite 39 Dienstag, 16. Mai 2006 4:42 16
MagicWatch MWE650
6.4
Fastening the control electronics
Note the following information when selecting a place to fit the control elec-
tronics:
Note the length of the sensor cables.
The control electronics are watertight and can be fitted inside or outside
the vehicle.
The control electronics may not be damaged if you have luggage or
objects in the boot.
If you fit the control electronics to the outside of the vehicle, they must be
protected against grit or similar dangers.
➤ Fasten the control electronics in a suitable position.
Note
The extension cables are marked: L (left), CL (centre left),
R (right), CR (centre right).
This marking helps you connect them to the control electronics to
ensure that the display is correct. These markings can also be
found on the control electronics.
The plug polarities cannot be reversed: They can be only be
plugged into the connection in one way.
➤ Insert the plugs of the sensor extension cables into the corresponding
sockets on the control electronics (see fig. 15 B, page 7).
Make sure the locking pin catches.
6.5
Fastening the display
Note the following information when selecting a place to fit the display:
The display must be easily visible when you are reversing.
Fit the display so that there is no danger of injury, for example when
sharply braking.
Do not fit the display where an airbag may open. This could cause injury
if the airbag opens.
Installing MagicWatch
39
Publicidad
