Waeco MagicWatch MWE650 Instrucciones De Montaje Y De Uso página 40

MWE-650-4DSM.book Seite 40 Dienstag, 16. Mai 2006 4:42 16
Installing MagicWatch
Its compact design means it can be fitted in many places in the vehicle.
Good positions are (see fig. 14, page 7):
– Above the rear view mirror
– On the dashboard
– On the ceiling
– On the window beside the wing mirror
➤ Pull off the protective foil and stick the display in a suitable position.
The plug's polarity cannot be reversed: It can be only be plugged
into the connection in one way.
➤ Insert the display plug into the socket of the corresponding extension
cable (see fig. 16 A, page 7).
➤ Lay the extension cable to the control electronics and insert the plug of
the extension cable into the socket on the control electronics (see
fig. 16 B, page 7).
6.6 Connecting the control electronics
Caution!
Make sure the polarity is correct.
On some vehicles, the reversing light only works when the ignition
is switched on. In this case, you must switch on the ignition in
order to identify the positive and negative wires.
➤ Connect the red cable (fig. 17.2, page 8) on the control electronics to the
positive wire (+) of the reversing light (fig. 17.1, page 8).
➤ Connect the black cable (fig. 17.3, page 8) to the earth wire (–) of the
reversing light or to earth (bodywork).
40
MagicWatch MWE650