Descargar Imprimir esta página

Atlas Copco W2820 Instrucciones De Operación Y Seguridad página 4

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 12
Safety and operating instructions
e.g. supplied from a fog lubricator (DIM) or Dosol
system.
This does not apply to turbine tools, which should
be kept oil free.
Compressed air connection
• The machine is designed for a working pressure
(e) of 6–7 bar = 600–700 kPa = 87–102 psi.
• Blow out the hose before connecting.
Handling
Tightening torque
The torque obtained depends on air pressure and
tightening time on the actual joint. Extensions and
worn sockets will reduce the delivered torque. The
impact wrench should be used within the specified
torque range. Never use the machine over recommen-
ded maximum torque. Might result in improper
function and faster wear.
Test methods
A static torque measurement is recommended for
impact wrenches.
For test on hydraulic tension tester and for test on
joints.
Maintenance
Service instructions
Overhaul and preventive maintenance is recommen-
ded at regular intervals once per year or after maxim-
um 100.000 tightenings depending on which occurs
sooner. More frequent overhaul may be needed if
the machine is used in heavy-duty operations. If the
machine not is working properly, it should immedi-
ately be taken away for inspection.
The strainer at the air inlet and the exhaust silencer
should be cleaned frequently or replaced in order to
prevent clogging, which decreases the capacity.
At the overhauls, all parts should be cleaned accur-
ately and defective or worn parts (i.e. O-rings, vanes)
should be replaced.
It is important that the machines threaded connec-
tions are tightened properly; i.e. in accordance with
the specifications on the exploded views. Before as-
sembly, lubricate the threads with grease.
A
All o-rings should be greased before assem-
bling.
4
Grease guide
Air lubrication
Brand
BP
Esso
Q8
Mobil
Shell
Texaco
Impact mechanism
Type of oil
SAE 20W-20
Rust protection and internal cleaning
Water in the compressed air, dust and wear particles
cause rust and sticking of vanes, valves etc. An air
filter should be installed close to the machine (see
'Air quality'). Before longer standstills, flush with
oil (some drops) into the air inlet, run the machine
for 5-10 seconds when absorbing the oil in a cloth.
Useful information
You can find all kind of information concerning Pro
products, accessories, spare parts, published matters
on our WEB site!
C Log in to www.pro-powertools.com
Technical data
Noise and vibration emission
Noise (in accordance with -)
Sound pressure level
Sound power level
Uncertainty
Vibration total value, valid from 2010
(3-axes value in accordance with -)
Vibration value
Uncertainty
Vibration value, valid until 2009
(1-axis value in accordance with -)
Vibration value
Noise and Vibration Declaration State-
ment
These declared values were obtained by laboratory
type testing in accordance with the stated standards
and are suitable for comparison with the declared
values of other tools tested in accordance with the
© Atlas Copco Tools - 9836 5320 00
W2820
Air tool oil
Energol E46
Arox EP46
Chpin 46
Almo oil 525
Tonna R32
Aries 32
Quantity
20 cc
dBA
95
106
-
2
m/s
7.9
1.7
2
m/s
-

Publicidad

loading

Este manual también es adecuado para:

8434 1248 20