LG LWHD1000CR Manual Del Usuario página 13

Horizontal Sliding Window Installation
1. Loosely attach the Support Bracket to the
bottom of Bracket using Bolts, Washer, and
Nuts. Attach the Leveling Bolt and Nut. (Fig.
1)
2. Remove protective backing from Window
Track Seal and apply seal to window track.
(Fig.2)
3. Measure and lightly mark a line 8-1/4 inches
from window jamb. Center the Support
Bracket assembly on the window track and
fasten with 4 Type C screws.(Fig. 2)
4. Put the Support Bracket against the outside
wall and tighten the Bolts on top of the
Bracket. Adjust the Leveling Bolt so that the
air conditioner will be installed with a very
slight tilt (about 1/4") downward toward the
outside for proper drainage.
Tighten the nut. (Fig. 3)
NOTICE
DO NOT drill a hole in the bottom of the base
pan. The air conditioner is designed to operate
with the bottom of the base pan approximately
half-full of water.
5. Fasten Side Guides to the sides of the Air
Conditioner using 3 Type A screws per Guide.
Start with first screw at middle of Guide.
(Fig. 4)
6. Fasten Upper Guide on the top of the Air
Conditioner using 3 Type A screws. (Fig. 4)
Washer
Nut
Support Bracket
Window Jamb Window Jamb Windo amb
1 1
8 8 / / inches inches
4 4
Windo Window Track Window Track
Seal Seal
Window Track Window Track Windo
1 / "
About
4
Fastening Side Guides
Upper Guide
°C
Installation
Bolt
Bracket
Leveling Bolt & Nut
Fig. 1
Type C screw Type C screw
Fig. 2
O u
t s i
d e
W a
Fig. 3
l l
Side Guide
Fig. 4
Owner's Manual 13