Publicidad
Idiomas disponibles
Idiomas disponibles
Hardware Needed
24
15
1/4" Locknut
Plastic Washer
(Qty. 2)
(Qty. 2)
14
1/4-20 x 2" Bolt
(Qty. 2)
20. Repeat steps from 1-16 on second half.
21. Attach linkages #4 to the OUTSIDE of U-support #7 on
second table half. Use Bolts #14, plastic washers #24
and hex nuts #15. See Figure 8.
NOTE: Tighten locknuts #15 finger tight
only. They will be removed when the
two table top halves are connected.
7
24
14
NOTE: Tighten locknuts #15 finger tight
only. They will be removed when the two
15
table top halves are connected.
Second Table Top
Figure 8
Figure 3
Figure 3
10
CAUTION:
AT LEAST TWO ADULTS ARE NEEDED
TO MOVE TABLE HALF!
15
24
14
4
Publicidad
