Publicidad
Idiomas disponibles
Idiomas disponibles
Hardware Needed
9
1/4-20 x 1 1/2 Bolt
(Qty. 2)
14
1/4-20 x 2" Bolt
(Qty. 2)
17. Attach other end of linkages #4 to OUTSIDE
of U-support #7 with bolts #14 and plastic
washers #24. Then slide name panel #5
onto the same bolts #14 on the INSIDE of
U-support #7. Secure with lock nuts #15 See
Figure 7B. Tighten hardware until snug but
do not overtighten. Tubes must pivot freely.
18. Attach bottom of name panel #5 to
U-supports #7. Secure with hex
bolts #9 and locknuts #15. Tighten
nuts but be careful not to crush
tubes. See Figure 7B.
19. Prepare an area for the assembly of the second table top
half. If necessary, move the first table top half aside with the
aid of a helper. Be sure to place it in a location where it
won't be disturbed or damaged. If setting on its side, be
sure to place the bottom edge no less than 12 inches
away form the wall. Also be sure to place carpet or pieces
of the shipping carton down to protect table top edges. If
floor is not carpeted, brace table top half with a heavy
object to keep it from sliding.
15
1/4" Locknut
(Qty. 4)
7
9
24
Plastic Washer
24
14
(Qty. 2)
AT LEAST TWO ADULTS ARE NEEDED
15
7
First Table Top
Figure 7B
Figure 3
Figure 3
9
CAUTION:
TO MOVE TABLE HALF!
15
4
5
9
24
14
Publicidad
