Publicidad
Idiomas disponibles
Idiomas disponibles
Important:
As for additional safety rules, we strongly recommends the tting of Photo Electric safety beams on all installations.
10) While installing the opener, strictly follow all the instructions given in the instruction manual. If some points or procedu-
res in this manual are not very clear,do not install the unit until all doubts have been cleared up with our technical depart-
ment.
Basic function setting and applying
Adjustable automatic - closing time
1) Travel limit setting Opening & closing force self-learning
2) Matching the receiver and transmitter
Figure A
Figure B
Press "SET'' button and hold on until the LED displays gure 1, then adjust the up limit
by pressing "up" button. Fine-tuning up or down button to determine the nal up
limit position then press "set'' button the display turn into "2'' automatically. Adjust the
down limit by pressing "down" button. Fine-tuning "up'' or "down'' button to determi-
ne the nal down limit position then press "set'' button. The opener will operate a
cycle automatically to remember the limit positions and the opening & closing force.
Press "CODE'' button and hold on until the LED dot is on. (Figure A) Then press any
button on the transmitter once, the dot will be o ; press the button again the dot will
fast ash then LED displays "11" (Figure B). After that the transmitter will be available.
Press "CODE" button more than 8 seconds until the LED displays "C", all the stored
codes will be deleted.
Opening your life
10
1
Publicidad
