Publicidad
Idiomas disponibles
Idiomas disponibles
Opening your life
Manual disengagement
The opener is equipped with a manual release cord to disengage shuttle and move door by hand while holding the handle
down (Figure 14). Pull on the handle to disengage the shuttle. To re-engage the door simply run opener in automatic mode
or move door by hand until the trolley engages in the chain shuttle.
In some situations that a pedestrian door is not in state, it is recommended that an external disengagement device should
be tted (Figure 15).
Figure 14
Figure 15
Maintenance
1) No particular maintenance is required for the logic circuit board.
Check the door at least twice a year if it is properly balanced, and all working parts are in
good working condition or not.
Check the reversing sensitivity at least twice a year, and adjust if it is necessary.
Make sure that the safety devices are working e ectively (photo beams, etc.)
Notice: A rude operating door can a ect the life of the automatic opener due to incorrect loads, and will void the warranty.
Final notes
This manual is only used by technical persons who are quali ed to carry out the installation.
No given information in this manual can be considered of any interest to the end user.
It is important for the installer to show their clients correct operation using of the opener including the using of manual
disengagement cord.
Inform the owner about the need of a regular and accurate maintenance, especially regarding a regular check of the safety
and reversing devices
13
1
Publicidad
