Polar GL180 Manual De Instrucciones página 4

EN
Pack Contents
The following is included:
• POLAR Refrigerator or Freezer
• Keys
• Shelf guides
• Instruction manual
POLAR prides itself on quality and service, ensuring
that at the time of unpacking the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.
Installation
Note: Not for use in vans or
trailers, food trucks or similar
vehicles.
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water then dry well.
3. Set the brakes on the castors to keep the
appliance in position.
4
GL180-GL181_ML_A5_v7_20230427.indb 4 GL180-GL181_ML_A5_v7_20230427.indb 4
Reversing the door
Depending on the location of the appliance, it may
be necessary to change the direction the door
opens by changing the side of the door handle.
• Polar recommends that the reversal of
the door is carried out by a competent
person(s).
• Should a product issue occur as a result
of reversing the door, any repair action
would be chargeable.
• If you require an engineer to carry out
the task please call a Polar agent.
• If you proceed yourself we recommend
you follow the steps outlined below
once the unit has been unplugged.
Failure to follow properly may void your
warranty.
The door originally opens from the left side.
To reverse the door, follow the instructions on
Pages44-46.
Removing the Compressor Safety
Band
• The compressor is located on the top of the
appliance, and sits on rubber washers. Under
normal operating conditions the compressor is
allowed to vibrate.
• To avoid damage through excessive motion
during transit, a stainless steel safety band is
placed over the compressor and screwed into
the top of the appliance.
• This safety band and the two screws fixing it
to the appliance must be removed before the
appliance is turned on.
Compressor
Safety Band
Compressor
Screws
2023/4/27 13:56 2023/4/27 13:56