Polar GL180 Manual De Instrucciones página 5

Lock/Unlock the Doors
A lock is fitted to the doors to ensure foodstuffs
are kept secure within your Polar appliance.
Use the keys provided to lock/unlock the doors.
Fitting the Waste Water Tray
The waste water tray comes ready to fit to the
underside of the appliance.
Slide the tray into the runners situated under
the appliance. (Note: Remove the rubber transit
packaging before installing.)
Fitting the Shelves & Floor Guards
1. Place one set of shelf guides on either side of
the cabinet at the desired height.
2. Slide the shelf into place.
3. Repeat for the remaining shelves.
4. Place the floor guards on the floor of the
cabinet, ensuring the flat side is clear of the
floor.
Note: This is vital for ensuring correct
drainage of condensation. If this is done
incorrectly, your appliance may get wet
and/or freeze on the bottom. In the event
of a complaint, this is not covered by the
warranty.
Operation
Storing Food
To get the best results from your Polar appliance,
follow these instructions:
• Only store foodstuffs in the appliance when it
has reached the correct operating temperature.
• Do not place uncovered hot food or liquids (like
acidic fluids) inside the appliance (as it can
damage the evaporator).
• Wrap or cover food where possible.
• Do not obstruct the fans inside the appliance.
• Avoid opening the doors for prolonged periods
of time.
Turn On
1. Ensure the power switch is set to [O] and turn
on at the socket.
2. Switch on the Power [I]. The current
temperature within the appliance is displayed.
GL180-GL181_ML_A5_v7_20230427.indb 5 GL180-GL181_ML_A5_v7_20230427.indb 5
Control Panel
To unlock / Lock the keyboard press
together for 3 seconds. Display will flash PON
(unlocked) / POF (locked).
Set the Operating Temperature
1. Press the SET button for 3 seconds. The
display will flash.
2. Press the or buttons to display the
required temperature.
3. Press the SET button to store the temperature.
Manual Defrost
Press and hold the defrost button "aux" for 2
seconds to begin a manual defrost. The defrost
light illuminates.
The defrost cycle will end automatically.
Cleaning, Care &
Maintenance
Defrost appliance at least every 3 months,
more often if required.
Switch off and disconnect from the power
supply before cleaning.
• Clean the interior of the appliance as often as
possible.
• Do not use abrasive cleaning agents. These
can leave harmful residues.
• Clean the door seal with warm soapy water.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run
through the drain hole into the evaporation
pan.
• Take care when cleaning the rear of the
appliance. Sharp edges can cut.
EN
and
5
2023/4/27 13:56 2023/4/27 13:56