Operator's guide:
1)Unpacking instructions
2)Cleaning the stainless steel shelf
3)Cleaning the cover and external parts
4)Holders for containers and pastry shelves
5)Connection to the mains
6)Operations and adjustment
7)Routine maintenance
!
WARNINGS (PAG.57)
It is most important that this instruction booklet is kept together with the appliance both for future
reference and for reasons of safety.
1
. Adults should operate this appliance only. Do not allow children to use the controls or play with it. . It
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
installation of the appliance should be carried out by a qualified electrician or other competent person.
4. Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare
5
6
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs.
7. The manufacturers of this appliance accept no responsibility for the consequences of misuse in
contravention of these safety instructions. It further reserves the right to carry out improvements without
prior notice. 8
. Avoid installing the cabinet directly in line with sunlight. . Nevere install the appliance near
sources of heat, such as radiators, stoves, etc.
11
least 30 cm.
. If damp air or products to be refrigerated should cause ice to form on the evaporator, we
recommend stopping the compressor and placing the goods in special refrigerated containers, kept at the
same temperature, until defrosting is completed;if this is not carried out the compressor will continue to
operate leading to a wasteful consumption of electricity and poor performance.
!
Our products are for internal use only – do not install outside restaurants, shops.
UNPACKING INSTRUCTIONS
1.
1a. Cut surrounding tape. Remove the cardboard package by sliding it upwards, remove the nails from
the wooden crate with care. . Lift the appliance.
a flat, level surface.
5.
Make sure there is nothing left in the package before disposing of it. . Sort out the
packaging materials in order to facilitate disposal. . The appliance can be locked in place by engaging
the wheel brakes (see picture 1).
CLEANING THE STAINLESS STEEL SHELF
2.
1
. Clean the tank using a soft sponge and neutral detergent. .Turn the tap on to eliminate any residual water.
3. Dry with a soft cloth. (see picture 3)
3.
CLEANING THE COVER AND EXTERNAL PARTS
1.
Use only a soft damp sponge. . Dry with a clean cloth.
HOLDERS FOR CONTAINERS AND PASTRY SHELVES
4.
1
. Remove the protection film from the holders. . Place the longer holders in the slots provided on the
basin's rims (see picture 3). . Place the shorter holders in the slots provided in the longer holders.
Different arrangements are available for different container sizes and positions.
containers on the holders
rims (containers and stainless steel shelves are available upon demand) (see picture 3).
CONNECTION TO THE MAINS
5.
1. Ensure that mains voltage and frequency are the same as those stated on the rating plate (A) attached
to the appliance (see picture 3). . Ensure that the supply socket:
requirements of the rated current as set out on the rating plate;
thermal-magnetic switch with In = rated value as stated on the rating plate; - differential with Id sensitivity
3
= 30 mA. . Ensure that there is no danger of explosion (AD) in the room. . Make sure the environment
is suitable for the power supply cable provided. The cable of the appliance is H05 VVF, designed for
internal use. . Insert the plug in the socket (do not use three-way adapters and reduction adapters).
5
N.B.: if the equipment has been transported or stored overturned, let is rest in its correct position for at
least 3 hours before hooking it up to the mains.
Operator's guide
10
. Keep the ventilation grills free from obstruction for at
2
3.
7
2
2
3
. 5.
For pastry models, you need only place the stainless steel shelves on the
2
Maintenance manual (Page 46):
1)Cleaning the condenser (skilled personnel only)
Wiring diagram diagram of refrigeration unit
9
Remove the pallet or crate. . Place the appliance on
2
is properly earthed;
a)
complies with the IEC regulations:-
c)
4
6
2
3
4
6
4.
You can now put your
fulfils the
b)
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO