Sicam JUMBO TCS56 Manual Origina página 29

4. First start up
4.1 Unpacking
1. Remove the packaging paying attention to nails
detaching.
i
After unpacking check the integrity of JUMBO TCS56
and check that no components are visibly damaged.
In case of doubt do not proceed to start-up and con-
tact a qualified technician and/or your vendor.
2. Take out of the transport crate the standard accesso-
ries and the packaging materials.
i
Dispose correctly of packaging material, hand it over
to the designated collection points.
4.2 Assembly
4.2.1 Machine positioning
1. Insert the appropriate lifting belts (length belt 1: 1.5
mt, belt 2: 2 m, with sufficient capacity, as shown.
Warning - tilting danger!
The barycentre of the JUMBO TCS56 does
not lie in its centre.
€
It is necessary to lift the machine slowly.
Sicam srl società unipersonale
First start up | JUMBO TCS56 | 29
2. Lift the JUMBO TCS56 with a lift crane and install it
in the designed area respecting the minimum distan-
ces shown in the picture.
i
For safe and ergonomic use of the JUMBO TCS56
it is recommended to leave a minimum of 750 mm
space from the nearest wall and of 900 mm from the
ceiling.
Warning - tilting danger!
During tire inflation considerable forces are
exerted.
€
The JUMBO TCS56 has to be fixed in at
least 3 points on the floor (screw holes see
chap. 4.2).
en
|
301 966 2010-11-18