Urrea EA1007A Manual página 11

1. Keep a firm grip with both hands on the tool.
Position your body properly to resist the force of
kickback. The operator can control torque reac-
tions if the correct warnings are taken.
2. Never place your hand close to the rotating
accessory. It can cause a kickback over your
hand.
3. Never place your body on the kickback area;
the kickback will propel the tool to the opposite
direction of the rotation abrasive disc.
4. Use extra care when working with edges.
These tend to engage the disc.
5. Don't use the tool with cutting saws. These
produce kickback.
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
2
4
1. SWITCH.
2. SPINDLE LOCK BUTTON.
3. ANTI-VIBRATION HANDLE SIDE.
4. DISC GUARD.
TECHNICAL DATA
EA1007A
VOLTAGE-FREQUENCY
NO LOAD SPEED
DISC CAPACITY
SPINDLE THREAD
POWER
WEIGHT
EA1009A
VOLTAGE-FREQUENCY
NO LOAD SPEED
DISC CAPACITY
SPINDLE THREAD
POWER
WEIGHT
1
3
120 V ~ 60 Hz
11 000 r/min
7" (180 mm)
5/8" (16 mm)
2 400 W
5,5 kg (12,12 lb)
120 V ~ 60 Hz
11 000 r/min
9" (230 mm)
5/8" (16 mm)
2 400 W
5,5 kg (12,12 lb)
E N G L I S H •
ASSEMBLY INSTRUCTIONS
WARNING: Remove the grinder from the
carton and examine it carefully. Do not discard
the carton or any packaging material until all
parts are examined.
LATERAL HANDLE
The lateral handle must
be used always that
the machine is run-
ning. Screw the lateral
handle inside the holes,
could be on
the right, left or superior side. Your choice is
determined by your convenience and ability to
keep the complete control.
GUARD
The guard is a security
device to prevent in-
juries caused by pieces
of abrasive disc. When
installing the guard,
make sure the raised rib aligns with the slot on
the cover of the gearbox. Then turn to the left
the protector until stays in the correct position.
Before the operation, make sure that the guard
is locked on place. Release the fixed screws, the
guard can be adjusted to the desired position.
Once done this, adjust the fixation screw.
INSTALL AND REMOVE THE ABRASIVE DISC
To Install:
1. Make sure that the guard is in its place.
2. Place the internal
adapter on the shaft.
Make sure that it is
placed on the two
plane surfaces.
3. Check the abrasive
disc speed. Don't use a
disc which speed range
is less than the indicated
on the label machine.
4. Press the spindle lock button, to prevent
movement.
5. Press and hold the
spindle lock button;
adjust the exterior
adapter screwing on
the clockwise direction
with the spanner.
To remove:
1. Press the shaft lock button.
2. Loosen the shaft lock nut by turning the nut
counterclockwise with the wrench.
Us er 's M an u a l
11