Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing
NOTE
• When the TV is turned on for the first time after
being shipped from the factory, initialization of
the TV may take approximately one minute.
• Image shown may differ from your TV.
• Your TV's OSD (On Screen Display) may differ
slightly from that shown in this manual.
• The available menus and options may differ from
the input source or product model that you are
using.
• New features may be added to this TV in the
future.
• The items supplied with your product may vary
depending upon the model.
• Product specifications or contents of this manual
may be changed without prior notice due to
upgrade of product functions.
• For an optimal connection, HDMI cables and
USB devices should have bezels less than 10 mm
thick and 18 mm width.
• Use an extension cable that supports USB 2.0 if
the USB cable or USB flash drive does not fit into
your TV's USB port.
• Use a certified cable with the HDMI logo
attached. If you do not use a certified HDMI
cable, the screen may not display or a
connection error may occur.
• Recommended HDMI cable types (3 m or less)
- High-Speed HDMI®/
- High-Speed HDMI ®/
A
• How to use the ferrite core
(Depending upon model)
- Use the ferrite core to reduce the
electromagnetic interference in the power
cable. Wind the power cable on the ferrite core
once.
[Cross Section of Ferrite Core]
[to a wall plug]
10 cm (+/- 2 cm)
6
cable
TM
cable with Ethernet
TM
B
B
A
*A 10 mm
*B 18 mm
[to the TV]
• Antenna Isolator Installation Guide
(Depending upon model)
- Use this to install TV in a place where there is a
voltage difference between TV Set and GND of
antenna signal. If there is a voltage difference
between TV Set and GND of antenna signal, the
antenna contact might be heated and excessive
heat might cause an accident.
- You can improve the safety when watching
TV by efficiently removing power voltage
from TV antenna. It is recommended to
mount the isolator to the wall. If it cannot
be mounted to the wall, mount it on the TV.
Avoid disconnecting the antenna Isolator after
installation.
- Before starting, be sure that the TV antenna is
connected.
Wall
ANTENNA/
or
CABLE IN
Cable /
Isolator
Antenna
Connect one end of the isolator to cable/antenna
jack and the other to TV set or set-top box.
"Equipment connected to the protective earthing
of the building installation through the mains
connection or through other equipment with
a connection to protective earthing - and to a
cable distribution system using coaxial cable,
may in some circumstances create a fire hazard.
Connection to a cable distribution system has
therefore to be provided through a device
providing electrical isolation below a certain
frequency range (galvanic isolator, see EN 60728-
11)"
When applying the RF Isolator, a slight loss of
signal sensitivity can occur.
1. Connect to TV
2. Connect to Set-Top box
Publicidad
